Home

Walter Bosley

20 April 2017 App Feed NightVision Radio Podcast


Did the Knights Templar Use Telluric Lines to Mark Their Hidden Treasure?

Thursday, March 30th, 2017at 10:30 pm EDT, join the resolute seeker of truth, René Barnett of NightVision Radio invites author and researcher Walter Bosley to explain how hidden Templar vaults along the telluric lines in America may yield some of the most sought after treasures of all time!

WALTER BOSLEY

Walter Bosley | Did the Knights Templar Use Telluric Lines to Mark Their Hidden Treasure?Walter Bosley is an investigator of historical occult mysteries, author of pulp fiction novels and a screenwriter. After nineteen years in national security, Walter Bosley is a licensed private investigator in California where he also runs his small press publishing company, Lost Continent Library, founded in 2002. Bosley has traveled much of the world, both on the job and off, including trips through Mexico and South America with David Hatcher Childress whose WEX Magazine has published articles by Bosley.

Walter Bosley was born in San Diego, California, and attended SDSU where he earned a B.A. in Journalism. He has been employed by the Federal Bureau of Investigation, is an inactive reserve officer in the US Air Force for which he served as a Special Agent of the AFOSI while on active duty, and worked as a counterterrorism consultant for six years following military service.

Where Can We See These Telluric Lines or Currents?

Telluric currents are phenomena observed in the Earth’s crust and mantle. In September 1862, an experiment to specifically address Earth currents was carried out in the Munich Alps (Lamont, 1862). Including minor processes, there are at least thirty-two different mechanisms which cause telluric currents. The strongest are primarily geomagnetically induced currents, which are induced by changes in the outer part of the Earth’s magnetic field, which are usually caused by interactions between the solar wind and the magnetosphere or solar radiation effects on the ionosphere. Telluric currents flow in the surface layers of the earth. The electric potential on the Earth’s surface can be measured at different points, enabling the calculation of the magnitudes and directions of the telluric currents and hence the Earth’s conductance. These currents are known to have diurnal characteristics wherein the general direction of flow is towards the sun Telluric currents continuously move between the sunlit and shadowed sides of the earth, toward the equator on the side of the earth facing the sun (that is, during the day), and toward the poles on the night side of the planet.

Both telluric and magnetotelluric methods are used for exploring the structure beneath the Earth’s surface (such as in industrial prospecting). For mineral exploration the targets are any subsurface structure with a distinguishable resistance in comparison to its surroundings. Uses include geothermal exploration, mining exploration, petroleum exploration, mapping of fault zones, ground water exploration and monitoring, investigation of magma chambers, and investigation of boundaries of tectonic plates. Earth batteries tap a useful low voltage current from Telluric currents, and were used for telegraph systems as far back as the 1840s.

In industrial prospecting activity that uses the telluric current method, electrodes are properly located on the ground to sense the voltage difference between locations caused by the oscillatory telluric currents. It is recognized that a low frequency window (LFW) exists when telluric currents pass through the earth’s substrata. In the frequencies of the LFW, the earth acts as a conductor. – source

Listen to the interview right here!


Share